Service &support

(It is recommended that the equipment be cleaned before working every day and shut down)

There are three mirrors and one focusing mirror on the laser machine (No.1 reflector is located at the exit of the laser tube, that is, the upper left corner of the machine, No.2 reflector is located at the left end of the beam, No.3 reflector is located at the top of the fixed part of the laser head, and the focusing mirror is located at the bottom of the laser head, which can be adjusted.

In the barrel, the laser is reflected and focused by these lenses and emitted from the laser hair. Lens are easily stained with dust or other contaminants, resulting in laser loss or lens damage. No. 1 and No. 2 lenses need not be removed when cleaning, just wipe the lens paper dipped with cleaning solution carefully along.

Rotary wiping from the center to the edge of the lens. The lens No. 3 and the focusing lens need to be removed from the frame and wiped in the same way. After wiping, they can be put back as they are.

Note: 1. Lens should be gently wiped, not to damage the surface coating; 2. Wipe process should be gently handled to prevent falling; 3. Focus lens installation must be kept concave face down.

The long-term use of the fan will accumulate a lot of solid dust in the fan, which makes the fan produce a lot of noise, and is not conducive to exhaust and deodorization. When the suction of the fan is insufficient and the smoke exhaust is not smooth, first turn off the power supply and remove the inlet and outlet ducts from the fan.

Dust, and then the fan upside down, and pull the blades inside, until clean, and then the fan installed.

It is recommended to clean every half month and shut down the machine.

As one of the core components of the equipment, the guide rail and straight axis play a guiding and supporting role. In order to ensure the machine has a higher processing accuracy, it is required that the guide rail and straight line have a higher guiding accuracy and good motion smoothness. During the operation of the equipment, due to being subjected to

Processing parts will produce a lot of corrosive dust and smog in the process. Based on these smog and dust deposited on the surface of guide rail and straight axis for a long time, it has a great impact on the processing accuracy of equipment, and will form corrosion spots on the surface of straight axis of guide rail to shorten the service life of equipment. For the sake of

The machine works normally and steadily to ensure the processing quality of the products. We should conscientiously do the daily maintenance of the guide rail and straight axis.

Attention: Clean guide, please prepare - dry cotton cloth, lubricating oil

After working for a period of time, the screw and coupling at the moving joint will be loosened, which will affect the stability of mechanical movement. Therefore, in the operation of the machine, it is necessary to observe whether there are abnormal sounds or abnormal phenomena in the transmission parts, and to find out the problems, it is necessary to strengthen and maintain them in time. Simultaneous machine

It should take some time to use tools to bolt one by one. The first solidity should be about one month after the equipment is used.

Suggestion: Clean water tank and replace circulating water once a week

Note: Make sure the laser tube is filled with circulating water before the machine works.

The water quality and temperature of the circulating water directly affect the service life of the laser tube. It is suggested that pure water be used and the water temperature be controlled below 35 C. If the temperature exceeds 35 C, the circulating water should be replaced, or ice cubes should be added to the water to reduce the water temperature. (It is suggested that the user choose the cooler or use two water tanks) Clean the water tank: first, turn off the power supply, pull out the water pipe in the intake, let the water in the laser tube flow into the water tank automatically, open the water tank, take out the water pump, and remove the fouling on the pump. Clean the water tank, replace the circulating water, return the pump to the water tank, insert the water pipe connecting the pump into the intake, and tidy up the joints. Power the pump separately and run for 2-3 minutes (fill the laser tube with circulating water).